You agree to get information about new jobs for this search by email. You can cancel email alerts at any time. Pierce Equipment: When smaller openings, like round or square holes, are required in a panel, a die punch is used (mounted in a die retainer, which is in turn mounted to a closing die surface). These hardened steel punches can be sharpened so that a single punch can survive the entire stamping procedure, sometimes tens of thousands of strokes. Pierce equipment normally refers to the male punch, the female die button, and the mounting retainers.
We have no power to the fuel pump wire at the tank, and have not been able to find a fuel pump relay although retrofit repair information shows that there is a fuel pump relay, but does not specify location. C1 Pin 19 at the ECM shows to be Fuel Pump Relay Control and C1 Pin 6 shows to be Fuel Pump Relay Return. Underhood power control center does not show any of the relays to be a ‘Fuel Pump Relay’.
The battery is the first part connected when first starting your vehicle. The battery must crank 100-200 amps in order to turn the starter against the flywheel and turn engine over. Your battery will produce up to twice or two-and-a-half times more cold cranking amps than is required to start the engine. The problem that still lies is, during extreme temperatures, the amperage capacity of the battery can be reduced to half its output. In addition, if the vehicle is parked outside in inclement weather, the flywheel and starter wheel can become frozen. A standard battery life is between five and seven years. Have your battery checked to see if it can handle the load your vehicle needs to withstand the winter season.
Imagine your refrigerator tipped over on its side, and maybe laid down on a set of drawers or two. Toolboxes of this size are an expensive investment and are rarely purchased just for show. A mechanic working out of one of these boxes has likely been doing it for a long time and has, over time, expanded this tool set through having done many different kinds of jobs. While this is not a promise that he or she is good, it’s a darn good indicator that this person has been working on cars for quite awhile.
Young people are under tremendous pressure today. Relentless study and exams, performance expectations, peer pressures, family pressures and so on. The most extraordinary thing is that, even with all this pressure, they’re still growing and developing, and aren’t even the people they’ll end up being!
You will be prompted for smart cards that you do not have. This is another important point. Do not press EXIT. If you do, you will be prompted to power off the tool and remove the memory card. You will have to start the installation all over and end up in a loop. You want to press enter. You will get a message that the feature will be loaded onto the tool but not authorized. That is ok. Just click enter again.